Topappliancesreviews.com is reader-supported. When you buy through links on our site, we may earn an affiliate commission. Learn more

How to Remove Rotten Egg Smell From Your Washing Machine

Prime for Young Adults: check your eligibility on Amazon

Clearing that sulfur stench usually comes down to cleaning the drain pump filter and running an empty hot cycle with regular chlorine bleach. That method works when trapped lint and detergent sludge breed bacteria inside the drum, but the solution changes completely if sewer gas is escaping from the household plumbing instead.

The right fix depends on where the odor actually starts. A dry curved pipe behind the wall (the P-trap that holds water to block fumes) allows sewer gas to back up around the drain hose, while bacteria in a home water heater can taint the hot water supply before it even fills the tub. Machine design matters too, since front loaders feature an access door for the catch screen while top loaders drain directly. Pinpointing the exact source takes just a minute and ensures the smell stays gone for good.

Pinpoint Where the Rotten Egg Smell Originates

Before you pour cleaners into the machine, identify exactly where the odor comes from. A sulfur or rotten egg stench usually points to hydrogen sulfide, which is a sulfur gas produced by decaying bacteria. In some cases, it signals sewer gas escaping into your home, or even an actual natural gas leak. Distinguishing between these sources protects your safety and prevents wasted effort.

If you smell sulfur throughout your home, near a gas furnace, or around a gas water heater, stop immediately. Utility natural gas has an added sulfur odorant called mercaptan so you can detect leaks quickly. If you suspect an actual fuel gas leak, do not flip light switches, do not start the washer, evacuate the house, and call your local gas utility or emergency services from outside.

If the smell remains confined to your laundry area, use this quick checklist to find the exact source:

  • Sniff inside the empty wash tub: Open the door or lid and take a close sniff right at the inner wash basket. If the stench hits you immediately from the metal drum or the rubber rim, bacteria have built up inside trapped soap scum, lint, and stagnant pump water.
  • Sniff behind the machine near the wall: Lean over the back of the washer and check the standpipe, which is the open upright pipe that receives the washer drain hose. If the odor is noticeably stronger behind the unit than inside the drum, sewer gas is likely venting past the drain trap into your laundry room.
  • Check your household hot water faucets: Run hot water from a nearby sink faucet into a clean glass, step away into another room, and smell the water. If the hot water smells like sulfur while cold water smells normal, bacteria are reacting with the magnesium anode rod inside your water heater tank rather than your washer.
  • Inspect the rubber door seal on front loaders: Pull back the folds of the flexible rubber door seal (gasket) with gloved fingers. If you see dark gray or black slime trapped between the folds, anaerobic bacteria are thriving in trapped wash water and hair.

Step-by-Step Guide to Removing the Rotten Egg Smell

Once you confirm the odor comes from inside the washer, you must clean out the organic matter that feeds the bacteria and sanitize the entire water pathway. Follow these steps in order to clear out the sludge and destroy the sulfur smell for good.

  1. Unplug the machine and clear the floor: Disconnect the power cord from the standard 120-volt 3-prong grounded wall outlet, shut off the hot and cold water supply valves, and place an old towel and a shallow baking sheet on the floor in front of the machine.
    Why this step matters: Cutting power eliminates shock risks while working near internal parts, and the shallow pan catches stagnant drainage water before it damages your flooring.
  2. Drain and clean the lower drain pump filter: On most front load washers, open the small access door at the bottom front corner, pull out the tiny rubber drain tube to release trapped water into your pan, and then unscrew the drain pump filter (a small catch screen that traps lint and hair). Rinse the screen under warm tap water and scrub away any trapped gray slime or coins with an old toothbrush.
    Why this step matters: This catch screen traps decaying threads, pet fur, and body oils in standing water, making it the most common breeding ground for hydrogen sulfide bacteria.
  3. Scrub the flexible rubber door seal: Mix a solution of equal parts warm water and liquid chlorine bleach, put on rubber gloves, and peel back the folds of the flexible rubber door seal. Wipe out all trapped lint, hair, and soap sludge using a microfiber cloth or soft sponge, then wipe the glass door where it meets the rubber.
    Why this step matters: Detergent scum and fabric softener pool in the bottom folds of the door seal, shielding odor-causing bacteria from regular wash water.
  4. Remove and rinse the detergent dispenser drawer: Press the release tab inside the dispenser drawer, pull it completely free from the machine, and soak it in warm water. Use a small brush to scrub out caked powder, slimy liquid residue, and mold from the compartments, then wipe the dry roof of the dispenser housing inside the washer frame before sliding the drawer back in.
    Why this step matters: Old detergent buildup inside the dispenser housing slowly drips into the tub between loads, providing fresh food for bacterial colonies.
  5. Add liquid chlorine bleach to the drum: Pour one cup of regular liquid chlorine bleach directly into the empty stainless steel clothes tub, or fill the bleach dispenser cup to the maximum fill line.
    Why this step matters: Liquid chlorine bleach penetrates bacterial biofilms, kills sulfur-producing microbes, and chemically oxidizes hydrogen sulfide molecules to neutralize the stench immediately.
  6. Run the hottest cleaning cycle available: Plug the washer back in, turn on the water shutoff valves, and select the dedicated tub clean setting. If your washer does not have a dedicated clean cycle, select the heavy-duty cycle with the hottest water temperature setting and the longest wash duration. Allow the machine to complete the full cycle without any laundry inside.
    Why this step matters: Scalding water dissolves greasy residues while the circulating bleach water floods the outer tub and internal hoses where stagnant bacteria hide.
  7. Run a second complete rinse cycle: Once the hot cycle finishes, select a normal cycle or a spin-only setting with an extra rinse using plain cold water, without adding any detergent or chemicals.
    Why this step matters: A thorough plain water rinse flushes out loosened slime particles and strips away any remaining bleach smell so your next load of clothes stays protected.
  8. Dry the interior and wipe down the surfaces: Use a clean dry towel to wipe down the inner wash basket, the door glass, and the rubber folds of the door seal. Leave the washer door or lid wide open for at least four to six hours.
    Why this step matters: Rapid evaporation stops damp pockets from lingering, keeping bacteria from immediately re-establishing colonies in the dark tub.

Safety Warning: Never Mix Bleach with Vinegar or Ammonia

When dealing with stubborn rotten egg smells, it is tempting to throw multiple household cleaners into the tub at the same time to speed up the process. Never combine liquid chlorine bleach with white vinegar, ammonia, or acid-based washing machine cleaners. Mixing these household chemicals causes dangerous, rapid chemical reactions that threaten your lungs and nervous system.

Combining chlorine bleach and vinegar creates toxic chlorine gas. Inhaling chlorine gas causes instant coughing, throat irritation, burning eyes, and breathing difficulties. Combining chlorine bleach with ammonia creates chloramine gas, which produces equally dangerous fumes that can trigger severe respiratory damage and fluid buildup in the lungs. Many commercial laundry detergents and stain removers contain small amounts of ammonia or acids, so always check the product labels before adding bleach.

If you prefer to clean your washing machine with white vinegar instead of chlorine bleach, use only one chemical at a time. Run a full cycle with vinegar, follow it with a plain water rinse cycle to clear out all acidic traces, and only then introduce any bleach-based product if the sulfur smell persists. If you ever smell a sharp, acrid, swimming-pool odor that stings your eyes while cleaning, immediately turn off the machine, open nearby exterior windows, leave the room, and get fresh air.

What to Do If the Smell Comes from the Wall Drain Pipe

If cleaning the wash tub, door seal, and drain filter does not solve the problem, the sulfur odor is likely entering your home from your plumbing rather than the washer itself. The washer discharges dirty water through a flexible drain hose into a standpipe, which is an open upright pipe connected to your home drainage system.

Below that standpipe sits a P-trap, which is a curved drain pipe that holds water to block sewer gas. The water sitting in the curve forms a physical seal that stops methane, hydrogen sulfide, and sewer odors from rising out of the municipal sewer line and into your laundry room. Several common plumbing issues can compromise this water barrier:

  • A dried-out trap: If you were away on vacation, or if the washer sat unused for several weeks, the water inside the curved P-trap can simply evaporate. Without that standing water barrier, sewer gas drafts straight up through the open standpipe. Pouring two or three quarts of clean tap water directly down the wall standpipe refills the curve and restores the vapor seal instantly.
  • The drain hose is shoved down too deep: If your washer drain hose is pushed more than 6 to 8 inches down into the wall standpipe, it can dip below the water level of the P-trap. When the machine discharges water, it creates a siphon that sucks the trap dry at the end of the drain cycle. Pull the hose back so only 4 to 6 inches rest inside the pipe, and secure it with a plastic hook bracket or zip tie to keep it from slipping down.
  • An unvented or clogged pipe: A partial clog of lint, pet hair, and dried detergent sludge deep inside the wall pipe can rot over time and produce its own sulfur gas. If the water drains sluggishly or gurgles loudly during the spin cycle, run a handheld plumbing auger (drain snake) down the standpipe to clear hair mats, or contact a licensed professional plumber to inspect the laundry drain vent.

Simple Laundry Habits That Prevent Sulfur Smells from Returning

Bacteria require three basic conditions to produce hydrogen sulfide gas: moisture, darkness, and organic food. Everyday laundry routines often create this environment by leaving damp clothes sitting inside a closed drum or coating the tub with excessive soap residue. Adopting a few simple washing habits will keep your laundry area smelling clean permanently.

Always leave the washer door or lid cracked open between wash loads. Keeping the door open lets room air circulate through the stainless steel clothes tub, evaporating moisture before bacteria can multiply. If you own a front load washer, keep a dry microfiber rag near the machine and quickly wipe out water sitting in the bottom groove of the flexible rubber door seal after your final load of the day. For appliances with specific maintenance settings, using a washer with a dedicated self-cleaning tub cycle once every month helps automate this deep-cleaning chore without harsh manual scrubbing.

Switch to a low-suds HE (High Efficiency) detergent and measure your doses carefully. Standard detergents produce excessive foam that modern low-water washers cannot rinse away effectively. That leftover soap creates a sticky film on the outer tub that collects skin cells, dirt, and lint. Using two tablespoons of HE detergent per normal load is usually plenty to clean clothes without leaving sticky food for bacteria. You can also review simple appliance upkeep methods that stop musty odors to keep the entire cabinet fresh between seasons.

Cut back on liquid fabric softeners. Traditional liquid softeners contain petroleum derivatives and animal fats designed to coat clothing fibers. That same waxy coating sticks to the outer walls of the wash basket, forming a thick sludge known as scrud. Replace liquid softeners with a half-cup of distilled white vinegar in the softener rinse dispenser, or switch to wool dryer balls in the dryer to soften fabrics without contaminating your washing machine drum.

Frequently Asked Questions

Is the rotten egg smell coming from my washing machine dangerous to breathe?

In low concentrations inside a laundry room, hydrogen sulfide from decaying bacteria is primarily an unpleasant nuisance that can cause minor headaches or mild eye irritation. If the smell originates from sewer gas backing up through an unsealed drain pipe, it may contain methane, which presents health and fire hazards over long periods. If you suspect an actual natural gas fuel leak, leave the home immediately and call your utility company.

Can I use baking soda and vinegar instead of bleach to clear the sulfur smell?

Baking soda and vinegar are helpful for mild sour odors, but they are generally too weak to destroy heavy bacterial biofilms and sulfur-producing microbes. When combined, baking soda and vinegar neutralize each other into basic saltwater and carbon dioxide gas, losing most of their grease-cutting strength. Liquid chlorine bleach or a specialized sodium percarbonate washing machine cleaner provides the oxidation power required to kill sulfur-producing bacteria completely.

Why does my washer only smell like sulfur when running hot water?

If the rotten egg smell appears only when the washer fills with hot water, the source is almost certainly your home water heater rather than the washing machine. Sulfur bacteria frequently colonize hot water tanks where they react with the sacrificial magnesium anode rod to generate hydrogen sulfide gas. You can verify this by checking hot tap water at a nearby sink to confirm whether the odor comes straight from the supply pipes.

How often should I clean the drain pump filter to prevent odors?

Clean the lower drain pump filter catch screen once every one to three months, depending on how often you wash pet bedding or heavily soiled garments. Routine cleaning prevents hair, coins, and lint from building up into a thick slime plug that traps standing water and breeds bacteria. Regularly wiping the door seal and running a monthly high-heat cleaning cycle will keep the pump catch relatively clean between manual checks.

4.3
3 ratings
Nicholas Ellis
WRITTEN BY
Nicholas Ellis
Nicholas is a home appliances editor based in Phoenix, Arizona. He is known for her expertise in modern kitchen appliances and their utilization in healthy cooking practices. With over 8 years of experience in the field, he brings a unique perspective in her reviews and guides.