How to Get Odor Out of a Washing Machine
A clean cycle finishes, but opening the door brings a blast of sour mildew instead of fresh laundry. The fastest remedy is to run an empty cycle on the hottest setting with a dedicated cleaner or bleach. That high heat dissolves the film of soap residue and bacteria that regular cold washes leave behind inside the drum.
The exact fix depends on the washer style and what kind of smell is coming out. Front-load washers usually hold trapped moisture and mold in the rubber door seal, while top-load machines hide grime right under the drum rim. A rotten egg smell points to a clogged drain pump filter or standing water rather than simple surface mold. Always use one cleaning agent at a time, because mixing bleach with vinegar creates toxic gas. Checking a few hidden spots will clear the stink and keep laundry smelling fresh.
Tracking Down Where Laundry Odors Hide Inside Your Washer
You pull a fresh load of laundry out of the machine, expecting the clean scent of fresh fabric, but instead you get hit with the smell of damp gym socks, old pond water, or sour milk. That bad smell is not coming from your clothes. It is coming from inside the appliance itself. Modern washing machines are engineered to save water and energy, but those same water-saving designs can easily trap moisture, body oils, and soap scum inside hidden mechanical spaces.
When you run low-temperature wash cycles, body grease and laundry detergent do not fully dissolve. Instead, they form a slick layer of biofilm along the water lines and drum walls. In an enclosed, humid environment, mold spores and bacteria multiply rapidly across that film. Top-loaders and front-loaders harbor these colonies in different spots. Front-load washers seal shut with an airtight door to prevent water leaks, which traps humidity inside the machine between washes. Top-load washers allow more air to circulate through the unsealed lid, but soap scum frequently cakes onto the underside of the plastic tub rim, beneath the center agitator post that twists clothes through the water, or under the flat bottom wash plate that moves laundry using water currents. If you are comparing machine styles, understanding the differences between top-load and front-load washers helps explain why each style develops distinct odor issues over time.
Before you run any deep-cleaning cycles, check these five common zones where odor-causing grime hides:
- The rubber door seal folds: The thick rubber boot around a front-loader door has deep folds that collect standing pools of dirty rinse water, slimy pet hair, and black mold colonies.
- The detergent dispenser drawer: Liquid fabric softener and thick detergents leave a gummy coating in the drawer channels and along the hidden overhead spray nozzles.
- The lower drain pump filter: Often called the coin trap, this small chamber collects coins, hairpins, and lint that slowly decompose in trapped, stagnant water.
- The upper rim of the wash basket: Splashing water leaves a ring of dried soap curd and lint around the top edge of the stainless steel clothes tub, completely out of normal sight.
- The drain hose and wall standpipe: A kinked drain hose or a loose connection to the wall pipe can let sewer vapors or backed-up greywater drift straight back into your wash tub.
Identifying the exact type of smell also tells you what you are dealing with. A stale, mushroom-like smell points to mold and mildew feeding on trapped dampness in the door seal or soap drawer. A sharp, sulfurous smell resembling rotten eggs usually points to decaying matter inside the lower drain pump filter or a dry plumbing trap in your wall.
Deep Cleaning the Tub With Heat and Sanitizing Cycles
Surface wiping cannot reach the hidden outer wall of the stainless steel clothes tub, where the thickest layer of mold and soap scum lives. To break that layer down, you need to run a high-heat maintenance wash that circulates sanitizing chemicals through every water channel in the appliance. Follow these numbered steps to flush out the drum thoroughly:
- Empty the wash drum completely: Remove all clothing, laundry bags, and stray socks from the machine. Check that the stainless steel clothes tub is completely bare so the sanitizing solution can coat the entire metal surface without absorbing into fabrics.
- Choose your sanitizing agent: You have two reliable choices for this drum wash: liquid chlorine bleach or a specialized washing machine cleaner tablet. Liquid chlorine bleach is exceptionally effective at killing active mold colonies and sanitizing the drum surfaces. Washing machine cleaner tablets rely on concentrated oxygen bleach and descalers (hard-water cleaners) that dissolve hardened mineral crusts and greasy soap films that bleach cannot cut through. Place the tablet directly into the empty bottom of the wash tub, or pour one cup of liquid chlorine bleach directly into the main wash compartment of the dispenser drawer.
- Observe the golden safety rule: Never combine liquid chlorine bleach with vinegar, ammonia, or any other household cleaning product. Mixing chlorine bleach with acidic cleaners produces toxic chlorine gas that causes severe coughing, eye burning, and respiratory damage. Pick either bleach or a dedicated cleaning tablet for your cycle, and never mix them together in the same wash.
- Select your hottest wash cycle: Turn your machine dial to the dedicated "tub clean" or "clean washer" setting if your unit includes one. This cycle fills the tub with extra hot water and agitates longer than a standard clothing cycle. If your machine does not have a tub clean setting, select the heavy-duty cycle, adjust the water temperature to the hottest available setting, and select an extra rinse. If you are researching appliance features, looking at which washing machine is best between front or top loaders will show you that many newer models include these high-heat cleaning cycles as standard features.
- Run the cycle through to completion: Allow the washer to run through its entire wash, drain, and high-speed spin cycle without interruption. The sustained heat works alongside the cleaning agent to soften hardened grime and wash it down the drain line.
- Wipe out loosened residue immediately: Once the machine chimes at the end of the cycle, open the door and inspect the drum. The intense wash action frequently dislodges flakes of brown or gray soap scum from behind the drum walls. Wipe the entire stainless steel clothes tub with a clean, dry microfiber cloth to remove those loose flakes before they dry and stick to your next load of shirts.
Clearing Out the Rubber Door Seal, Soap Drawer, and Drain Filter
Running a hot drum cycle sanitizes the main wash tub, but water sprays do not reach every crevice of your washer. The rubber door seal, the soap drawer, and the lower drain filter require direct, hands-on cleaning to clear out physical blockages that produce foul smells. Tackle these three areas in order to eliminate lingering odors completely.
Start with the rubber door seal on front-load machines. Put on rubber cleaning gloves, grip the flexible rubber lip at the bottom of the door opening, and peel it backward toward yourself. You will likely see a dark, slimy residue consisting of lint, dog hair, and black mold colonies sitting in the drainage trough. Spray the rubber fold with a solution of warm water and mild dish soap, or use a cloth dampened with diluted bleach. Scrub the rubber thoroughly using an old toothbrush or a soft sponge, making sure to clean both the top fold and the underside. Look closely at the small drain weep holes along the bottom crease of the rubber. If these tiny holes are clogged with lint, rinse water cannot drain back into the tub, leaving a permanent pool of stagnant water. Poke a cotton swab or a blunt toothpick through the holes to clear any trapped lint, then wipe the entire rubber seal completely dry with an old towel.
Next, pull out the detergent dispenser drawer. Liquid fabric softener and thick, low-suds HE (High Efficiency) detergent leave behind a sticky, petroleum-like film that attracts airborne mold spores. Pull the soap drawer forward until it stops. Look for a small plastic release lever or push tab, usually labeled "push," located right behind the fabric softener compartment. Depress that tab with your thumb and pull the drawer straight out of the washer frame. Disassemble the removable plastic siphon caps from the softener and bleach wells. Soak all the plastic pieces in a basin of hot, soapy water for ten minutes, then scrub away all hardened residue with a small brush. Before sliding the drawer back into the machine, take a damp rag or a bottle brush and reach inside the dark hollow cavity in the washer housing. Wipe down the upper ceiling inside that housing, where water spray jets often develop black mold patches. Once clean, snap the siphon caps back into place and slide the drawer into the housing until the locking tab clicks.
Finally, clean out the lower drain pump filter. Most front-load washers and select modern top-loaders house this filter behind a small access panel located at the bottom front corner of the machine. This filter catches solid debris before it can jam the electric drain pump impeller. When hair, coins, and sodden lint get trapped here, they sit submerged in stagnant water and create an intense sewage smell. Follow these steps to clean the filter safely:
- Turn off the washing machine and unplug it from the wall outlet for safety.
- Open the small lower access door on the bottom front panel using a flat tool or your fingernail.
- Lay several thick old towels and a shallow baking sheet flat on the floor directly beneath the filter door to catch escaping water.
- Locate the small rubber drain hose sitting next to the round filter plug, if your model has one. Pull the hose forward, remove its stopper, and drain the trapped water into a small bowl until it stops dripping. Put the stopper back securely.
- Slowly twist the main round filter cap counterclockwise. A rush of foul-smelling water will pour out onto your towels.
- Pull the filter screen completely out of the housing chamber. Pick off all tangled hair, lint clumps, coins, and paper residue by hand.
- Rinse the filter screen under running hot tap water in a utility sink, scrubbing it with a stiff nylon brush until the mesh is clear.
- Shine a flashlight into the empty pump cavity inside the washer. Wipe out any slimy residue with a damp paper towel and verify that the pump impeller blades at the back turn freely.
- Slide the clean filter back into the chamber. Twist it clockwise until it stops firmly against its rubber gasket. Screw it in tightly to prevent water leaks during your next wash, then snap the outer door shut.
How Dedicated Washer Cleaners Help Prevent Persistent Odors
Wiping down accessible parts stops surface mold, but preventing odors from returning requires breaking down the invisible soap scum and hard water scale that clings behind the drum. While household items like vinegar provide temporary relief for light sourness, vinegar is a mild acid that struggles to cut through heavy deposits of animal fats and synthetic polymers found in modern laundry detergents. Using pure vinegar frequently can also weaken the flexible rubber door seal and degrade internal rubber drain hoses over time.
Dedicated washing machine cleaner tablets solve this issue by combining concentrated oxygen-based bleaching agents with specialized descalers (hard-water cleaners). When dropped into a hot tub clean cycle, these tablets dissolve slowly over forty to sixty minutes rather than washing down the drain immediately. This sustained chemical action creates a rich, grease-cutting foam that rises into the narrow gap between the stainless steel clothes tub and the outer plastic wash drum, stripping away calcified mineral crusts and trapped organic slime that your hands cannot physically reach.
When selecting a washing machine cleaner to keep your appliance fresh, keep a few practical factors in mind before purchasing:
- Low-suds compatibility: Ensure the cleaner is explicitly rated for low-suds HE (High Efficiency) washing machines. Standard foaming soaps produce excessive suds that confuse the water-level sensors and trigger drain error codes on modern digital control boards.
- Descaling capability: If your home has hard tap water, choose a cleaner formulated with citric acid or dedicated descaling salts. Hard water minerals bind with detergent to create a chalky curd that locks in foul odors; a dedicated descaler breaks those mineral bonds so the residue washes away cleanly.
- Scent profile: Look for formulas that match your household preferences. Some tablets use fresh citrus or crisp eucalyptus oils to neutralize musty basement odors immediately, while fragrance-free oxygen tablets focus solely on neutralizing bacteria without leaving perfumes behind.
- Multipack count: Consistent monthly maintenance is the only way to keep washer odors from coming back. Buying a multi-count pack ensures you have enough tablets on hand to treat the machine every four weeks without interrupting your laundry routine.
- TAR Score9.6
TAR Score is a ranking system developed by TopAppliancesReviews.com. TAR score has no relationship or impact from any manufacturers or sales agent websites. Learn more
- BrandOxiClean
- TAR Score8.9
TAR Score is a ranking system developed by TopAppliancesReviews.com. TAR score has no relationship or impact from any manufacturers or sales agent websites. Learn more
- BrandiO CLEAN
- TAR Score8.8
TAR Score is a ranking system developed by TopAppliancesReviews.com. TAR score has no relationship or impact from any manufacturers or sales agent websites. Learn more
- BrandMolly's Suds
- TAR Score7.9
TAR Score is a ranking system developed by TopAppliancesReviews.com. TAR score has no relationship or impact from any manufacturers or sales agent websites. Learn more
- BrandMolly's Suds
Last update on 2026-10-30 / Affiliate links / Images, Product Titles, and Product Highlights from Amazon Product Advertising API
FAQs
Why does my washing machine smell like rotten eggs or sewage?
A rotten egg smell usually means gray water is stagnating inside your lower drain pump filter or sewer gases are escaping from your home plumbing. If the drain pump filter catches lint and hair, that organic material rots inside the standing water trap and pushes sulfur odors up into the drum. Alternatively, if your drain hose sits too deep inside the wall standpipe, it can siphon sewer vapors backward into the machine. Clear out your lower drain pump filter first, and confirm your drain hose has a proper air gap at the wall pipe.
How often should I clean my washing machine to keep it fresh?
Run a dedicated high-heat cleaning cycle once every month under normal household laundry conditions. If your household washes heavily soiled sports gear, pet bedding, or cloth diapers, clean the machine every two to three weeks instead. You should also clean the machine more frequently if you run most of your laundry on cold-water settings, because cold water fails to dissolve body oils and detergent films completely.
Can I run vinegar through the washer right after a bleach cleaning cycle?
No, you should never run vinegar through your washing machine right after using chlorine bleach without running plain water rinses first. Mixing residual bleach with acidic vinegar produces hazardous chlorine gas, which can severely irritate your eyes, nose, and respiratory system. If you just finished a bleach sanitizing cycle, run two complete rinse cycles with plain hot water to clear the drum and hoses completely before introducing vinegar or any other cleaning product.
Related guides: how to get petrol smell out of washing machine.

























